BUILT-IN MATHEMATICA SYMBOL
ExclusionsStyle
- The following settings can be given:
-
| s | use style s for the interiors of excluded subregions |
| {s,sb} | use style  for the boundaries of excluded subregions |
| None | leave excluded subregions blank |
| Automatic | draw excluded subregions the same as outside |
- The styles s and
can use color, thickness, point size and other graphics directives. Composite directives can be given using Directive.
- For single-parameter plotting functions such as Plot, ExclusionsStyle->s specifies that style s should be used to render lines joining opposite sides of each excluded point. ExclusionsStyle->{s, sb} uses style
for the endpoint of the curves on either side of an excluded point.
- For two-parameter plotting functions such as Plot3D, ExclusionsStyle->s uses style s to render the ruled surface that joins opposite sides of each excluded curve. ExclusionsStyle->{s, sb} uses style
for the boundary curves of the surfaces on either side of an excluded curve.
- For DensityPlot, ExclusionsStyle->s is taken to be equivalent to ExclusionsStyle->{s, s}.
Use red to show excluded portions of the surface:
| Out[1]= |  |
Use transparency to show excluded portions of the surface:
| Out[1]= |  |
Use red around the edges of the excluded portions of the surface:
| Out[1]= |  |
Use red lines to connect portions of the curve and blue points where there are jumps:
| Out[1]= |  |
Use black to indicate discontinuities in the density:
| Out[1]= |  |
New in 6
