WOLFRAM SYSTEM MODELER
ControlledIdealIntermediateSwitchControlled ideal intermediate switch |
SystemModel["Modelica.Electrical.Analog.Ideal.ControlledIdealIntermediateSwitch"]
This information is part of the Modelica Standard Library maintained by the Modelica Association.
The intermediate switch has four switching contact pins p1, p2, n1, and n2. The switching behaviour is controlled by the control pin. If its voltage exceeds the value of the parameter level, the pin p1 is connected to pin n2, and the pin p2 is connected to the pin n1. Otherwise, the pin p1 is connected to the pin n1, and the pin p2 is connected to the pin n2.
In order to prevent singularities during switching, the opened switch has a (very low) conductance Goff and the closed switch has a (very low) resistance Ron.
The limiting case is also allowed, i.e., the resistance Ron of the closed switch could be exactly zero and the conductance Goff of the open switch could be also exactly zero. Note, there are circuits, where a description with zero Ron or zero Goff is not possible.
Please note: In case of useHeatPort=true the temperature dependence of the electrical behavior is not modelled. The parameters are not temperature dependent.
useHeatPort |
Value: false Type: Boolean Description: = true, if heatPort is enabled |
---|---|
T |
Value: 293.15 Type: Temperature (K) Description: Fixed device temperature if useHeatPort = false |
level |
Value: 0.5 Type: Voltage (V) Description: Switch level |
Ron |
Value: 1e-5 Type: Resistance (Ω) Description: Closed switch resistance |
Goff |
Value: 1e-5 Type: Conductance (S) Description: Opened switch conductance |
heatPort |
Type: HeatPort_a Description: Conditional heat port |
|
---|---|---|
p1 |
Type: PositivePin Description: Positive pin of an electrical component |
|
p2 |
Type: PositivePin Description: Positive pin of an electrical component |
|
n1 |
Type: NegativePin Description: Negative pin of an electrical component |
|
n2 |
Type: NegativePin Description: Negative pin of an electrical component |
|
control |
Type: Pin Description: Control pin: if control.v > level p1--n2, p2--n1 connected, otherwise p1--n1, p2--n2 connected |