WOLFRAM SYSTEM MODELER
Ideal electrical opener
This information is part of the Modelica Standard Library maintained by the Modelica Association.
The ideal opening switch has a positive pin p and a negative pin n. The switching behaviour is controlled by the input signal control. If control is true, pin p is not connected with negative pin n. Otherwise, pin p is connected with negative pin n.
In order to prevent singularities during switching, the opened
switch has a (very low) conductance Goff
and the closed switch has a (very low) resistance Ron.
The limiting case is also allowed, i.e., the resistance Ron of the
closed switch could be exactly zero and the conductance Goff of the
open switch could be also exactly zero. Note, there are circuits,
where a description with zero Ron or zero Goff is not possible.
Please note: In case of useHeatPort=true the temperature dependence of the electrical behavior is not modelled. The parameters are not temperature dependent.
Use with care: This switch is only intended to be used for structural changes, not for fast switching sequences, due to the quasistationary formulation.
Description: =true, if heatPort is enabled
Type: Temperature (K)
Description: Fixed device temperature if useHeatPort = false
Type: Resistance (Ω)
Description: Closed switch resistance
Type: Conductance (S)
Description: Opened switch conductance
Description: Positive quasi-static single-phase pin
Description: Negative quasi-static single-phase pin
Description: Conditional heat port
Description: true => switch open, false => p--n connected
Description: Complex voltage
Description: Complex current
Description: Auxiliary variable
Multiphase ideal opener