WOLFRAM SYSTEM MODELER
InverterConverts from DC to AC |
 |
Diagram
Wolfram Language
In[1]:=
SystemModel["IndustryExamples.Energy.UPS.Components.Inverter"]
Out[1]:=
Information
This simplified inverter generates a constant sine wave that is only used when the potential sensor has a higher value than what is specified in realToBoolean.threshold. The potential sensor reads the value of the voltage provided by the battery.
Parameters (1)
| lowerVoltageLimit |
Value: Type: Voltage (V) Description: Limit where the inverter can't supply full voltage |
|---|
Connectors (2)
 |
pin_p |
Type: PositivePin Description: Positive pin of an electrical component |
|---|---|---|
 |
pin_n |
Type: NegativePin Description: Negative pin of an electrical component |
Components (12)
 |
signalVoltage |
Type: SignalVoltage Description: Generic voltage source using the input signal as source voltage |
|---|---|---|
 |
potentialSensor |
Type: PotentialSensor Description: Sensor to measure the potential |
 |
ground |
Type: Ground Description: Ground node |
 |
sine |
Type: Sine Description: Generate sine signal |
 |
switch1 |
Type: Switch Description: Switch between two Real signals |
 |
realToBoolean |
Type: RealToBoolean Description: Convert Real to Boolean signal |
 |
const |
Type: Constant Description: Generate constant signal of type Real |
 |
resistor |
Type: Resistor Description: Ideal linear electrical resistor |
 |
idealClosingSwitch |
Type: IdealClosingSwitch Description: Ideal electrical closer |
|
ground1 |
Type: Ground Description: Ground node |
|
resistor1 |
Type: Resistor Description: Ideal linear electrical resistor |
|
resistor2 |
Type: Resistor Description: Ideal linear electrical resistor |
Used in Examples (2)
 |
IndustryExamples.Energy.UPS Model of an uninterruptible power supply that controls the supply of power to a load. |
 |
IndustryExamples.Energy.UPS Model of a uninterruptible power supply with a non-standard battery reliability. |