WOLFRAM SYSTEM MODELER
IdealIntermediateSwitchIdeal intermediate switch |
SystemModel["Modelica.Electrical.QuasiStatic.SinglePhase.Ideal.IdealIntermediateSwitch"]
This information is part of the Modelica Standard Library maintained by the Modelica Association.
The intermediate switch has four switching contact pins p1, p2, n1, and n2. The switching behaviour is controlled by the input signal control. If control is true, the pin p1 is connected to pin n2, and the pin p2 is connected to the pin n2. Otherwise, the pin p1 is connected to n1, and p2 is connected to n2.
In order to prevent singularities during switching, the opened switch has a (very low) conductance Goff and the closed switch has a (very low) resistance Ron.
The limiting case is also allowed, i.e., the resistance Ron of the
closed switch could be exactly zero and the conductance Goff of the
open switch could be also exactly zero. Note, there are circuits,
where a description with zero Ron or zero Goff is not possible.
Please note:
In case of useHeatPort=true the temperature dependence of the electrical
behavior is not modelled. The parameters are not temperature dependent.
Use with care: This switch is only intended to be used for structural changes, not for fast switching sequences, due to the quasi-static formulation.
useHeatPort |
Value: false Type: Boolean Description: = true, if heatPort is enabled |
---|---|
T |
Value: 293.15 Type: Temperature (K) Description: Fixed device temperature if useHeatPort = false |
Ron |
Value: 1e-5 Type: Resistance (Ω) Description: Closed switch resistance |
Goff |
Value: 1e-5 Type: Conductance (S) Description: Opened switch conductance |
heatPort |
Type: HeatPort_a Description: Conditional heat port |
|
---|---|---|
p1 |
Type: PositivePin Description: Positive quasi-static single-phase pin |
|
p2 |
Type: PositivePin Description: Positive quasi-static single-phase pin |
|
n1 |
Type: NegativePin Description: Negative quasi-static single-phase pin |
|
n2 |
Type: NegativePin Description: Negative quasi-static single-phase pin |
|
control |
Type: BooleanInput Description: true => p1--n2, p2--n1 connected, otherwise p1--n1, p2--n2 connected |
s1 |
Type: Complex Description: Complex number with overloaded operators |
|
---|---|---|
s2 |
Type: Complex Description: Complex number with overloaded operators |
|
s3 |
Type: Complex Description: Complex number with overloaded operators |
|
s4 |
Type: Complex Description: Auxiliary variables |
|
unitVoltage |
Type: ComplexVoltage Description: Complex electric voltage |
|
unitCurrent |
Type: ComplexCurrent Description: Complex electric current |
Modelica.Electrical.QuasiStatic.Polyphase.Ideal Polyphase ideal intermediate switch |