WOLFRAM SYSTEMMODELER

PartialElementaryTwoFlangesAndSupport

Obsolete partial model. Use PartialElementaryTwoFlangesAndSupport2.

Diagram

Wolfram Language

In[1]:=
SystemModel["Modelica.Mechanics.Translational.Interfaces.PartialElementaryTwoFlangesAndSupport"]
Out[1]:=

Information

This information is part of the Modelica Standard Library maintained by the Modelica Association.

This is a 1-dim. translational component with two flanges and an additional support. It is used e.g., to build up elementary ideal gear components. The component contains the force balance, i.e., the sum of the forces of the connectors is zero (therefore, components that are based on PartialGear cannot have a mass). The support connector needs to be connected to avoid the unphysical behavior that the support force is required to be zero (= the default value, if the connector is not connected).

Parameters (1)

useSupport

Value: false

Type: Boolean

Description: = true, if support flange enabled, otherwise implicitly grounded

Connectors (3)

flange_a

Type: Flange_a

Description: Flange of left shaft

flange_b

Type: Flange_b

Description: Flange of right shaft

support

Type: Support

Description: Support/housing of component

Components (2)

internalSupport

Type: InternalSupport

Description: Internal support/housing of component as a model with connector flange (flange is either connected to support, if useSupport=true, or connected to fixed, if useSupport=false)

fixed

Type: Fixed

Description: Fixed support/housing, if not useSupport