WOLFRAM SYSTEM MODELER

PartialElementaryTwoFlangesAndSupport2

Partial model for a component with one translational 1-dim. shaft flange and a support used for textual modeling, i.e., for elementary models

Wolfram Language

In[1]:=

SystemModel["Modelica.Mechanics.Translational.Interfaces.PartialElementaryTwoFlangesAndSupport2"]

Out[1]:=

Information

This information is part of the Modelica Standard Library maintained by the Modelica Association.

This is a 1-dim. translational component with two flanges and an additional support. It is used e.g., to build up elementary ideal gear components. The component contains the force balance, i.e., the sum of the forces of the connectors is zero (therefore, components that are based on PartialGear cannot have a mass). The support connector needs to be connected to avoid the unphysical behavior that the support force is required to be zero (= the default value, if the connector is not connected).

Parameters (1)

useSupport	Value: false Type: Boolean Description: = true, if support flange enabled, otherwise implicitly grounded

useSupport

Value: false

Type: Boolean

Description: = true, if support flange enabled, otherwise implicitly grounded

Connectors (3)

	flange_a	Type: Flange_a Description: (left) driving flange (flange axis directed into cut plane, e. g. from left to right)
	flange_b	Type: Flange_b Description: (right) driven flange (flange axis directed out of cut plane)
	support	Type: Support Description: Support/housing of component