WOLFRAM SYSTEM MODELER
ElasticBearingExample to show possible usage of support flange |
SystemModel["Modelica.Mechanics.Rotational.Examples.ElasticBearing"]
This information is part of the Modelica Standard Library maintained by the Modelica Association.
This model demonstrates the usage of the bearing flange. The gearbox is not connected rigidly to the ground, but by a spring-damper-system. This allows examination of the gearbox housing dynamics.
Simulate for about 10 seconds and plot the angular velocities of the inertias housing.w
,
shaft.w
and load.w
.
shaft |
Type: Inertia Description: 1D-rotational component with inertia |
|
---|---|---|
load |
Type: Inertia Description: 1D-rotational component with inertia |
|
spring |
Type: Spring Description: Linear 1D rotational spring |
|
fixed |
Type: Fixed Description: Flange fixed in housing at a given angle |
|
springDamper |
Type: SpringDamper Description: Linear 1D rotational spring and damper in parallel |
|
torque |
Type: Torque Description: Input signal acting as external torque on a flange |
|
ramp |
Type: Ramp Description: Generate ramp signal |
|
idealGear |
Type: IdealGear Description: Ideal gear without inertia |
|
housing |
Type: Inertia Description: 1D-rotational component with inertia |
|
multiSensor |
Type: MultiSensor Description: Ideal sensor to measure the torque and power between two flanges (= flange_a.tau*der(flange_a.phi)) and the absolute angular velocity |